How to Install
Installation
Instructions
Printer-Friendly Installation Instructions
(in English PDF)
Printer-Friendly Installation Instructions
(in Spanish PDF)
Dig
Safely. Please comply with "Call Before You Dig" law
requiring utility markouts; the national telephone number is 888-258-0808.
Always wear appropriate safety attire, including protective eyewear.
- Leaving burlap intact, heel the plant's root ball into place.
- Remove plastic safety caps from Tree Staples™ and set aside.
Set
each Tree Staple™ opposite the other and against the outside edge
of the root ball. The shorter prong should be positioned over the root
ball, halfway between the trunk and the ball's outer edge.- Using a sledgehammer, drive each Tree Staple into the ground until the cross bar is recessed one to two inches below the surface of the root ball. You can alternate between hitting either of the prongs to insure that the Tree Staples are completely below-grade.
- Place safety caps on exposed ends.
- Cut back burlap, leaving material under cross bars.
- Fill and finish planting using best practices.
At your
discretion consider increasing the size or number of stabilizers when:
Extreme
wind conditions persist,
- The tree's
size requires greater holding power
- Soil is
sandy or loose
- Root ball is small relative to canopy or tree size, (palm trees).
"Virtually
invisible once installed. Congratulations on an innovative solution!"
–Jan-Marie
Traynor, Coordinator & Professor , Agricultural Technology Program,
County College of Morris
Loose
Root Ball or Container Stock:
Here's a simple and effective solution to use when working with container
stock or loosened B&B material:
Follow
steps 1, 2, & 3 in Installation Instructions, changing the position
of the short prong to the outside edge of the rootball.- Tie common burlap tree wrap (3"-5" width) to the crossbars on each side of the trunk. Leave about 2"-3" of play in the straps. Keep straps away from the trunk
- Proceed with installation instructions, step #4.
 |
 |
